02/10/2021 - some more tweaking - 4h

Not many pictures this time. Spend an afternoon on continued tweaking for the match of the windscreen bottom to the slider and get the spacing right in the bottom.

As you see in the picture, the windscreen nicely aligns with the top op the fuselage front top skin.
You can also see at the number 2 position no longer aligns with the drilled hole. I'll have to redrill those. Fortunatly there's enough space.

As mentioned in the previous article: first finish the windscreen completly (also the bottom) before doing any drilling.

Articles in Finish Kit

Finishing Kit

Legal Mumbo-Jumbo

It’s possible (not likely) that I’m not as smart as I think I am. (Occasionally, I have moments when I know this to be true. Fortunately, the feeling passes quickly.) Although I have tried to make this information as accurate as I can, it is not only possible, but also quite likely, that erroneous and misguided information lurks within these pages. I cannot and do not warrant these pages to be error free and correct. Furthermore, I accept no liability for the use of this (mis)information. And, as many would say, your mileage may vary. If, after reading this, you are intent on proceeding, please be aware that the contents of this site are protected by copyright (copyright © 2011 and 2012). Nonetheless, you may copy this material subject to these two conditions: (1) any information used is for non-commercial purposes, and (2) the source of the material is properly credited. Of course, you may link to any page herein. At some articles, snippets of the plans from Vans are visible. These are for educational and illustrations purposes only and should never be used as plans for part construction or assembly as plans may have changed since the picture was taken and more important they are protected by Copyright by the Vans Aircraft Mothership company.