01/11/2023 - Aileron trim 3 - 2h30

Short work session with some more work on the ailerontrim. This time I installed the molex pins on the trim motor and added  some heat shrink for stiffening the electrical wires coming out of the motor case.

 Pins inserted in the molex connector.

Next ran some wires to Bus Bar 1 to connect the aleron trim push button wires to the VPX (later replaced towards the Dynon SV_AP_Panel as in my case, Dynon receives and controls the trims through the autopilot system).


Site Options

Legal Mumbo-Jumbo

It’s possible (not likely) that I’m not as smart as I think I am. (Occasionally, I have moments when I know this to be true. Fortunately, the feeling passes quickly.) Although I have tried to make this information as accurate as I can, it is not only possible, but also quite likely, that erroneous and misguided information lurks within these pages. I cannot and do not warrant these pages to be error free and correct. Furthermore, I accept no liability for the use of this (mis)information. And, as many would say, your mileage may vary. If, after reading this, you are intent on proceeding, please be aware that the contents of this site are protected by copyright (copyright © 2011 and 2012). Nonetheless, you may copy this material subject to these two conditions: (1) any information used is for non-commercial purposes, and (2) the source of the material is properly credited. Of course, you may link to any page herein. At some articles, snippets of the plans from Vans are visible. These are for educational and illustrations purposes only and should never be used as plans for part construction or assembly as plans may have changed since the picture was taken and more important they are protected by Copyright by the Vans Aircraft Mothership company.