Redo F713 aux longerons and F7101 gear attach web - 11/03/2015

It's been a rough ride the last couple of weeks which prevented me from continuing on the plane.

As you may have noticed in the last articles, there was a lot of 'redo' and 'remake' in my blog. This was a clear indication that I needed a break and some weeks away from the project.

So now we are March and it's time to pickup where we left of

I had to reorder the F7101's and F713's after a mess up as you can read in the previous articles.

Today drilled the F713 on the right side and the lower row of holes on the F7101.
 F7101 mates much better now from the start and still sufficient edge distance on the longeron.


Site Options

Legal Mumbo-Jumbo

It’s possible (not likely) that I’m not as smart as I think I am. (Occasionally, I have moments when I know this to be true. Fortunately, the feeling passes quickly.) Although I have tried to make this information as accurate as I can, it is not only possible, but also quite likely, that erroneous and misguided information lurks within these pages. I cannot and do not warrant these pages to be error free and correct. Furthermore, I accept no liability for the use of this (mis)information. And, as many would say, your mileage may vary. If, after reading this, you are intent on proceeding, please be aware that the contents of this site are protected by copyright (copyright © 2011 and 2012). Nonetheless, you may copy this material subject to these two conditions: (1) any information used is for non-commercial purposes, and (2) the source of the material is properly credited. Of course, you may link to any page herein. At some articles, snippets of the plans from Vans are visible. These are for educational and illustrations purposes only and should never be used as plans for part construction or assembly as plans may have changed since the picture was taken and more important they are protected by Copyright by the Vans Aircraft Mothership company.